ISO 12103-1 PDF

Future revisions of ISO will accommodate changes in technology affecting test dust manufacturing processes and insure product consistency for years. ISO A2 Fine Test Dust Particle Size Distributions (Volume % Less Than). size. ISO A2 Fine. – – – ISO Road vehicles – Test contaminants for filter evaluation – Part 1: Arizona test dust.

Author: Tokasa Shagore
Country: Grenada
Language: English (Spanish)
Genre: Politics
Published (Last): 2 May 2010
Pages: 43
PDF File Size: 20.90 Mb
ePub File Size: 14.24 Mb
ISBN: 851-9-46297-870-7
Downloads: 47989
Price: Free* [*Free Regsitration Required]
Uploader: Vojas

The suspension is stirred and drawn through an aperture using a vacuum source. Share this product Tweet. West Coast Sales Sparks Blvd.

Test Sand & Test Dust

The bi-modal aspect of this product traces back to the original roller analysis specification of Fine Test Dust shown in former revisions of SAE J Specification. Particle sizes 121031- than 30 microns are given as reference values.

To the best of our knowledge since we are an active global distributor of all test dust and sands, ISO test dust is a non- contaminant and non-hazardous Class 121031- material. The small particle procedure, using fine dust is performed to ascertain the ability of equipment to resist the effects of fine particles which may penetrate into cracks, crevices, bearings, and joints.


The nominal specific gravity is 2. Although it is not currently specified as a suitable 121033-1 for cabin air filters, it is used as a test 11203-1 for fuel system components, water filter performance evaluation, and other custom applications. Material Safety Data Sheet. The intent in producing a separate standard for the description of test dust was to provide isl simple and accurate test dust reference for use in other standards or documents where test dust use is required.

Sold in gram net weight quantities b Packaging can be customized to accommodate the larger quantity ordered c Bulk Density: Particle counting is a mainstay of contamination control in hydraulic, automotive, and aerospace applications. Shanghai Jun Yu Trade Co. It was originally developed for testing automotive cabin air filters. It specifies four grades of test dust including dust description, designation, particle size distribution, particle size analysis procedure, and chemical content. Samples from only two batches were used because only two batches of this type dust were produced prior to when ISO particle size limits were determined.

Future revisions of Iao will accommodate changes in technology affecting test dust manufacturing processes and insure product consistency for years to come. Standard Materials for Calibration.

A view of volume differential particle size data indicates a bi-modal distribution with approximate peaks at 4 and 20 micron size. Four grades of test dust are designated in ISOa description of each is as follows: RoomBuilding 5, No.


Test Sand & Test Dust

Particle size limits specified per ISO are expressed as cumulative volume percent smaller than and listed as follows: Certified and reference values for the cumulative number of dust particles per unit volume of hydraulic oil greater than the specified particle diameter are reported.

A naturally occurring irregularly shaped mineral dust suspended in hydraulic oil at a nominal concentration of 2. Certified values for particles sizes from 1 micron to 30 microns are provided.

The Multisizer IIe analyzer measures particles 12103-11 by volume mass. Consists of 20 grams of dry dust taken from the same lot as the dust in SRMand is provided with reference values from 1 micron to 50 microns.

Particles for analysis are suspended in an electrolyte solution. Particles are measured as they pass through the aperture.