HEXFET® Power MOSFET. IRFD • Dynamic dv/dt Rating. • For Automatic Insertion. • End Stackable. • °C Operating Temperature. • Fast Switching. IRFD datasheet, IRFD pdf, IRFD data sheet, datasheet, data sheet, pdf, International Rectifier, 60V Single N-Channel HEXFET Power MOSFET in a. IRFD MOSFET N-CH 60V A 4-DIP Vishay IR datasheet pdf data sheet FREE from Datasheet (data sheet) search for integrated circuits ( ic).
|Published (Last):||26 November 2005|
|PDF File Size:||5.34 Mb|
|ePub File Size:||10.38 Mb|
|Price:||Free* [*Free Regsitration Required]|
I went through a list of commonly used parts and picked a non-SMT part which seemed to meet the specifications. MichaelKaras Thanks for pointing this out!
(PDF) IRFD Datasheet PDF Download – Power MOSFET(Vdss=60V/ Rds(on)=ohm/ Id=A)
If through-hole is important, it might be easier to get a physically larger package, like an IPAK. Typically the datasheet is much simpler to interpret. Hence it isn’t worth designing something close to an edge which might use time later to check and debug it.
That might be a way to make an SMD device usable within a through-hole technology design.
(PDF) IRFD014 Datasheet download
Sign up using Facebook. For simplicity, I would use a part specified with an Rds on for a Vgs of 4. If this is a one off, or small volume system, I would make a ‘no-brain’ assumption, to make life easier, and, at least, double the required current to get a minimum device current.
Post as a guest Name. This will raise the temperature increase in your FET at load. Further the part is clearly specified by the manufacturer to work in that region. From the datasheet, I think it should be fine to use: There are quite a few parts which are specifically irf0d14 at 4.
Sign up using Email and Password. When you give the gate something in the range of 4. Is there plenty of space? From the datasheet, I think it should be fine to use:. I’d recommend using a device with lots of headroom. JonasWielicki – Yes, that looks like a robust solution. Home Questions Tags Users Unanswered. Email Required, but never shown.
For small volumes the difference in part cost is likely a small fraction of an hour of my time. Do we have to expect any problems when driving the gate with less than that?